 |
Main features |
| 1. |
Single Station Extrusion Blow Moulding Machine |
| 2. |
Ø 90 or Ø 100 mm. 25 L/D Bobbing Extruder & Screw, operated by D.C. Motor drive |
| 3. |
300 points thickness parison control operated by servo-proportional-valve |
| 4. |
From Single up to Four Cavities Head capability, made by W. Muller Gmbh. |
| 5. |
PWDS-SFDR system capability (optional) |
| 6. |
All carriage horizontal movements on silent linear balls rails |
| 7. |
All hydraulics movements operated by closed-loop proportional valve system |
| 8. |
Tie bar-less clamping unit allowing easy and fast mould change |
| 9. |
Integrated automatic deflashing station |
| 10. |
Post cooling station/s capability (optional) |
| 11. |
Automatic system to take out the bottles produced, in line |
| 12. |
Machine fully controlled by microprocessor operating system & Can-Open communication |
| 13. |
Colour Screen control panel on the machine front |
| 14. |
Electrical system equipped with dust-proof and moist-proof protection |
| 15. |
General electric cabinet on the machine side |
| 16. |
Low power consumption with special hydraulic system |
| 17. |
Additional optional available on request |